Outboard / DI Outboard / Verado Coverage

ENGINE

Internally lubricated parts contained within the block to include: pistons, piston rings and pins, main and rod bearings, crankshaft, connecting rods, camshaft, camshaft bearings, valves, valve springs, guides and seats, reeds and reed blocks. Timing chain, gears and/or belts. Seals and gaskets of a covered component if defective. Engine head(s), engine block and/or cylinder barrels, intake manifolds only if damaged beyond repair as a result of a mechanical breakdown of one of the above covered components.

LOWER UNIT

Internally lubricated parts contained within the gear case. (Gear case if damaged beyond repair by a covered component). Seals and gaskets of a covered component if defective.

JET DRIVE

Internally lubricated parts contained within the pump housing. (Pump housing if damaged beyond repair by a covered component). Seals and gaskets of a covered component if defective.

FUEL DELIVERY

Fuel delivery pump (mechanical/diaphragm), carburetor body, air box (silencer), electric choke solenoid (enrichener). Seals and gaskets of a covered component if defective.

ELECTRICAL

Alternator/stator, voltage regulator/rectifier, engine mounted terminal blocks, engine mounted wiring harness, starter motor, starter armature, starter field windings, starter magnets, brush holder and brushes, end caps and bushings, starter drive, starter solenoid.

IGNITION

Power Pack/Switch Box, Amplifier, ignition high output coil, ignition trigger coil, spark plug wires.

POWER TRIM

Power trim motor, power tilt motor, power trim cylinders, including cylinder rams, cylinder seals, cylinder mounts and pivots, power trim motor actuator solenoids, power trim wiring harness, power trim master control switches, reverse lock valve, manual trim cylinder, manual trim cable, and control valve.

CONTROLS

Shift and throttle control box parts to include: cams, eccentrics, shafts, pivots, bushings, housing, control arms/levers and knobs, shift control cable, throttle control cable, ignition switch.

MECHANICAL STEERING

Control helm assembly, control rack and yoke assembly, power steering pump, power steering cylinder, steering wheel, steering wheel mounting hub. (Excludes cables). Seals and gaskets of a covered component if defective.

HYDRAULIC STEERING (MANUAL SYSTEMS)

Hydraulic steering head, hydraulic steering lines, hydraulic steering cylinder, hydraulic steering flow valves, steering yoke. (Excludes cables). Seals and gaskets of a covered component if defective.

OIL INJECTION SYSTEMS

Oil injection pump, oil pump drive gear, oil pump drive shaft, oil tank, oil tank cap, oil level sensors, oil level warning horns and lights, oil injection lines, oil injection check valves, oil injection metering system.

EFI/DFI COMPONENT COVERAGE

Electric fuel delivery pumps (high and low pressure), fuel injectors, fuel distributors, ECU module, throttle position sensor, manifold air temperature sender, idle speed control, mass air flow sensor, detonation/knock sensor, ignition pick-up sensor. Seals and gaskets of a covered component if defective.

Engine Only Coverage

If Engine Only Box is checked off under Options on the Administrator copy of the Application, Coverage will ONLY apply to ENGINE and LOWER UNIT components as indicated above.

Optional Accessory Programs

Accessory Programs are available as options on Your Service Contract provided that the option purchased is so noted on the Administrator copy of Your Service Contract application. Should the Stand-alone option box be checked on the Administrator copy of Your Service Contract application, coverage will be limited to components listed in the Optional Pak checked on Your application.

CRUISING PAK

Air Conditioner: Compressor, condenser, capacitor, relays, water pump, fans, heat exchanger, evaporator, thermostat.

Heating Unit: Heating elements, control panel, thermostat.

Interior Lighting: Light switches, lighting fixtures.

12-Volt/24-Volt Electrical: Battery charger/converter.

Shore Power: Onboard receptacle, cap, shore power main switch, circuit panel, circuit breakers.

Appliances (Built-in): Refrigerator, range/cook top, oven, L.P. regulator, clothes washer, clothes dryer, microwave, ice-maker, disposal.

Water System: water pump, water heater, compressor, drain system, sump pump, fittings, faucets.

Waste System: shower, toilet, sink(s), holding tanks, macerator, gate valves, connections, electric flush control, vacuum pump. Note: pipes and leaks from piping and vacuum accumulations are excluded.

Dual Station/Tower Control Set: Helm control, steering wheel, throttle/shift control box.

Horns: Air horns, air horn compressor, air solenoids, control panel, electric horn and control.

Electrical: Battery main switch, battery isolator, battery selector switch, battery box, fuse block/fuse holders, chart light, windshield wiper motor, transom light, bow light, docking lights, courtesy lights, accessory switches.

Anchor: Winch, electric windlass motor, bow pulpit guide, control panel.

Depth Finder: Depth sounder, transducer, mounting brackets and control cable. (Applies to one factory installed unit only).

Instrument Panel: (Factory installed only) Tachometer, speedometer, volt gauge, hour meter, oil pressure gauge, trim gauge, fuel gauge, temp gauge.

Stereo: CD Player, CD changer, amplifier, cassette tape deck, AM/FM tuner. (Factory installed units only).

Compass: Compass head, mounting brackets (excludes digital model).

Remote Spotlight: Control panel, horizontal/vertical control motors, light housing.

Planing/Trim Tabs: Pump, trim cylinders, planing plates.

Hardware: Deck rails, grab rails, hand rails, bow eyes, rope cleats, anchor chocks, cockpit steps, top slides, door hinges and latches, deck plates, storage cover sockets and supports.

*Blockage: Blocking coverage per foot of hull length per covered mechanical breakdown, up to $50.00 on covered claims.

*Dockside Assistance: (26 foot vessels and over only). Dockside Assistance covers up to $50.00 of service call charges when in water repair is needed.

*Not included if Cruising Pak is purchased as a Stand Alone option.
SPORT FISH PAK

Electric Trolling Motor** Armature, fields, brushes, brush holders, wiring harness, control cables, foot control unit and switches. Planitary/ armature housing if damaged beyond repair by one of the above.

Gas Trolling Motor (up to 15 HP)*: All internally lubricated parts contained within the engine block; fuel pump, carburetor; wiring harness, control cables, foot control unit and switches.

Electrical System: Battery main switch, battery isolator, battery selector switch, battery box, fuse block/fuse holders, chart light, electric horn, windshield wiper motor, transom light, bow light, docking lights, voltmeter.

Water System/Washdown: water pumps, drain system, fittings, faucets.

Live Wells: fill, pumps, aerator, manual valves, timer.

Power Transom/Jack Plate: Motor bracket, slides, jack screws, cylinder, control panel.

Planing/Trim Tabs: Pump, trim cylinders, planing plates.

Anchor: Winch, guide (Excludes anchor rope, cable or chain).

Digital Depth Finder: Depth sounder, transducer, mounting brackets and control cable. (Applies to one factory installed unit).

Fish Finder: Fish finder, transducer, speed and temperature sensors, mounting brackets, control cable. (Applies to one factory installed unit).

Battery Charger: (Factory installed unit only).

Speedometer: Speedometer head, speed log, mounting brackets and control cable.

Lakewater Temp Gauge: Temperature gauge, temp sensor and control cable (Hull mounted only).

Compass: Compass head, mounting brackets (Excludes digital models).

Boat Hardware: Deck rails, grab rails, hand rails, bow eyes, rope cleats, anchor chocks, cockpit steps, rod holders, top slides, door hinges and latches, deck plates, storage cover sockets and supports.

Trailer: Brakes, brake drums, master cylinder and hydraulic brake actuator. Frame rails, wheel bearings, spindles and springs, winch stand, welds, axle, hubs, backing plates, coupler, bunks and roller cradles. (Excludes damage due to overloading and bending or bearing failures due to water entry or debris).

** One motor only as originally equipped.
RUNABOUT PAK

Digital Depth Sounder: Depth finder, transducer, mounting brackets and control cable. (Applies to one factory installed unit).

Fish Finder: Fish finder, transducer, speed and temperature sensors, mounting brackets, control cable. (Applies to one factory installed unit).

Electrical: Interior courtesy lights, docking/bow lights, stem light, dual battery switch, cabin light fixtures, electric horn, windshield wiper motor.

Planing/Trim Tabs: Pump, trim cylinders, planing plates.

Waste System: shower, toilet, sink(s), holding tanks, macerator, gate valves, connections. Note: pipes and leaks from piping and vacuum accumulations are excluded.

Water System/Washdown: water pumps, drain system, fittings, faucets.

Stereo: CD Player, amplifier, cassette tape deck, AM/FM tuner. (Factory installed units only).

Appliances (Built-in): Galley sink and faucet, ice box, stove top.

Hardware: Stainless steel deck railings, grab rails, bow eyes, rope cleats.

Instrument Panel (Factory installed): Tachometer, speedometer, volt gauge, hour meter, oil pressure gauge, trim gauge, fuel gauge, temp gauge.

Trailer: Brakes, brake drums, master cylinder and hydraulic brake actuator. Frame rails, wheel bearings, spindles and springs, winch stand, welds, axle, backing plates, coupler, bunk and roller cradles. (Excludes damage due to overloading and bending or bearing failures due to water entry or debris).
SKI BOAT PAK

Digital Depth Finder: Depth finder, transducer, mounting brackets and control cable. (Applies to one factory installed unit).

Electrical: Interior courtesy lights, docking/bow lights, stem light, dual battery switch, cabin light fixtures, electric horn, windshield wiper motor.

Stereo: CD Player, amplifier, cassette tape deck, AM/FM tuner. (Factory installed units only).

Water/Ballast System/Washdown: water pumps, drain system, fittings, faucets.

Hardware: Stainless steel deck railings, grab rails, bow eyes, rope cleats.

Instrument Panel (Factory installed): Tachometer, speedometer, volt gauge, hour meter, oil pressure gauge, trim gauge, fuel gauge, temp gauge.

Trailer: Brakes, brake drums, master cylinder and hydraulic brake actuator. Frame rails, wheel bearings, spindles and springs, winch stand, welds, axle, backing plates, coupler, bunk and roller cradles. (Excludes damage due to overloading and bending or bearing failures due to water entry or debris).
NAV PAK

Navigation System: Radar, GPS, GPS Map Receiver, LORAN, Plotter, Loran Antenna, Auto Pilot, VHF Radio.
GENERATOR PAK (Coverage is limited to the first 1500 hours of use for New Craft and 750 hours of use for Used Craft)

Engine: Internally lubricated parts contained within the cylinder block to include: Pistons, piston rings and pins, main bearings and rod bearings, crankshaft, connecting rods, camshaft, camshaft bearings, timing chain, gears and/or belt, valves, valve springs, valve guides and seats, valve push rods, lifters, oil pump. Rocker arm cover, harmonic balancer, oil pan, engine mounts. Distributor housing, shaft and bearings. Seals and gaskets of a covered component if defective. Engine head(s), engine block and/or cylinder barrels, intake manifolds only if damaged beyond repair as a result of a mechanical breakdown of one of the above covered components.

Electrical: Switch box/amplifier, alternator, voltage regulator/rectifier, ignition coil, starter motor, solenoid, engine mounted wiring harness.

Closed Cooling System: Engine water coolant circulating pump and heat exchangers. (For closed cooling system only).

Generator Electrical: Armature, fields, brushes, end frame and housing, generator mounted control panel, rectifier. (Does not include installation and/or removal of unit).
TRAILER PAK

Trailer: Brakes, brake drums, master cylinder and hydraulic brake actuator. Frame rails, wheel bearings, spindles and springs, winch stand, welds, axle, backing plates, coupler, roller cradles. (Excludes damage due to overloading and bending, and bearing failures due to water entry or debris).

Benefits

HOIST/HAUL-OUT: The Contract will pay up to $100.00 for the actual cost of Hoist/Haul-Out anytime a covered component fails requiring Hoist/Haul-out to facilitate diagnosis or repairs (except where prohibited by law). Any reimbursement shall be the actual Hoist/Haul-Out charges in excess of any applicable reimbursement from any other party, including but not limited to, a manufacturer, association or insurer.

TOWING: The Contract will pay up to $100.00 for towing anytime a covered component fails causing the Craft to be towed either in water or on land (except where prohibited by law). Any reimbursement shall be the actual Towing charges in excess of any applicable reimbursement from any other party, including but not limited to, a manufacturer, association or insurer. Towing must be performed by a valid marine towing company or authorized marine service facility.

PICK-UP/DELIVERY: The Contract will pay up to $100.00 for the actual cost of Pick-Up/Delivery for Craft up to 25 feet anytime a covered component fails requiring Pick-Up/Delivery to facilitate diagnosis or repairs (except where prohibited by law). Any reimbursement shall be the actual Pick-Up/Delivery charges in excess of any applicable reimbursement from any other party, including, but not limited to, a manufacturer, association or insurer.